We read every piece of feedback, and take your input very seriously.
To see all available qualifiers, see our documentation.
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
The kill switch should stop the drone but leave it connected. I recommend 'esc', but it might be good to allow the user to set a different value.
The user should also be able to check the status of the kill switch and reset it.
The kill command should keep sending kill until the drone responds. It should also block any further commands until the kill switch is reset.
The text was updated successfully, but these errors were encountered:
scerruti
No branches or pull requests
The kill switch should stop the drone but leave it connected. I recommend 'esc', but it might be good to allow the user to set a different value.
The user should also be able to check the status of the kill switch and reset it.
The kill command should keep sending kill until the drone responds. It should also block any further commands until the kill switch is reset.
The text was updated successfully, but these errors were encountered: