This document explains how to orient and print the various printed parts. This guide uses Slic3r
All parts (other than the handle) should be printed with an infill of 100% and layer height of 0.2mm. The handle should be printed with an infil of 20%. When printing in Petg, if you have trouble getting the handle to fit, print the handle at 2% larger, and if you have trouble getting the neck_led_holder to fit, print it at 2% smaller.
The following parts can be printed without any supports from the 3mf file uploaded:
- Battery holder
- Handle
- Label plate
- Lens large
- Lens small
- Neck cover plate
- Neck led holder
- Plate pins
- Head
- Button cover
The following can be printed with full supports if needed:
- Head
- Button cover
Orient the parts as in the build plate below:
