Error Codes and what they mean

[jazzmonger]

Error codes are enum type and display specific values which you can then decode as follows. These are the most common. when I flash my stove in my shop, I'll decipher all the short/open states and include them here as well.

        esph_house_error_code_decoded:
         value_template: >
          {% set Pval2 = states('sensor.esph_house_stove_error_code') | float(0)  %}
          {% if   Pval2  == 32768 %} E2 Failure to ignite Pot 
          {% elif Pval2  == 16384 %} E1 Fire went out, likely out of pellets
          {% elif Pval2  == 2048 %} E5 Door is open
          {% elif Pval2  == 256 %} MCU Comms failed. Check tx/rx wires &  Restart Stove            
          {% elif Pval2  == 32 %} ESO3 OPEN at the room sensor, replace sensor
          {% elif Pval2  == 16 %} ESC3 SHORT at the room sensor, replace sensor                  
          {% elif Pval2  == 8 %} ESO1 OPEN at the h.temp sensor, replace sensor
          {% elif Pval2  == 4 %} ESC1 SHORT at the h.temp sensor, possibly on P1 - chg to P2 or lower
          {% elif Pval2  == 2 %} ESO2 OPEN at the protection sensor.  replace sensor
          {% elif Pval2  == 1 %} ESC2 SHORT at the protection sensor.  replace sensor
          {% elif Pval2  == 0 %} Normal Operation
          {% endif %}
           
        esph_house_bs_error_yesno:
          value_template: >
            {% if is_state('binary_sensor.bs_stove_error',  'on') %} Yes
            {% elif is_state('binary_sensor.bs_stove_error',  'off') %} No
            {% endif %}

        esph_house_bs_error_10:
          value_template: >
            {% if is_state('binary_sensor.bs_stove_error',  'on') %} {{60}}
            {% elif is_state('binary_sensor.bs_stove_error',  'off') %} {{55}}
            {% endif %}

        esph_stove_error:
          value_template: "{{ states('sensor.esph_house_stove_current_temp')|float(0) +4  <= states('sensor.esp
![Stove Errors](https://user-images.githubusercontent.com/52110065/207148227-0ad51ab2-43d4-4429-8a75-e81bde0b4ebf.png)
h_house_stove_set_temp')|float(0) }}"

This lets you display the last error in Lovelace