forked from myelin/arduino-cmsis-dap
-
Notifications
You must be signed in to change notification settings - Fork 0
/
target_struct.h
55 lines (45 loc) · 1.57 KB
/
target_struct.h
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
/* CMSIS-DAP Interface Firmware
* Copyright (c) 2009-2013 ARM Limited
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#ifndef TARGET_H
#define TARGET_H
#include <stdint.h>
typedef struct {
uint32_t breakpoint;
uint32_t static_base;
uint32_t stack_pointer;
} FLASH_SYSCALL;
typedef struct {
uint32_t init;
uint32_t uninit;
uint32_t erase_chip;
uint32_t erase_sector;
uint32_t program_page;
FLASH_SYSCALL sys_call_param;
uint32_t program_buffer;
uint32_t algo_start;
uint32_t algo_size;
const uint32_t * image;
uint32_t ram_to_flash_bytes_to_be_written;
} TARGET_FLASH;
typedef enum {
RESET_HOLD, // Hold target in reset
RESET_PROGRAM, // Reset target and setup for flash programming.
RESET_RUN, // Reset target and run normally
RESET_RUN_WITH_DEBUG, // Reset target and run with debug enabled (required for semihost)
NO_DEBUG, // Disable debug on running target
DEBUG // Enable debug on running target
} TARGET_RESET_STATE;
#endif