Cameras which support Runcam device protocol, can be configured using sticks.
Note that for cameras which has OSD pin, there is alternative functionality: OSD Joystick.
Camera's RX/TX should be connected to FC's UART, which has "Runcam device" option selected.
Emulation can be enabled in unarmed state only.
Joystick emulation mode is enabled using the following stick combination:
RIGHT CENTER
Than camera OSD can be navigated using right stick. See Controls for all stick combinations.
Note that the same stick combination is used to enable OSD Joystick.
Mode is exited using stick combination:
LEFT CENTER
There are 3 RC Boxes which can be used in armed and unarmed state:
- Camera 1 - Simulate Wifi button
- Camera 2 - Simulate POWER button
- Camera 3 - Simulate Change Mode button.