KlipperScreen.conf

#~# --- Do not edit below this line. This section is auto generated --- #~#

#~#
#~# [main]
#~# invert_z = True
#~# move_speed = 43
#~# print_sort_dir = date_desc
#~# screen_blanking = off
#~# 
#~# [displayed_macros Printer]
#~# backup_cfg = False
#~# dump_parameters = False
#~# force_t0 = False
#~# dump_config_vars = False
#~# force_t1 = False
#~# dump_vars = False
#~# g27 = False
#~# end_print = False
#~# hyperlapse = False
#~# m117 = False
#~# get_timelapse_setup = False
#~# load_filament = False
#~# m125 = False
#~# purge_line = False
#~# home_if_needed = False
#~# power_off_printer = False
#~# pause = False
#~# m76 = False
#~# timelapse_render = False
#~# _low_temp_check = False
#~# _reload_hotend = False
#~# resume = False
#~# m701 = False
#~# m702 = False
#~# _switch_extruder = False
#~# set_wled = False
#~# start_print = False
#~# _unload_hotend = False
#~# set_loaded_extruder = False
#~# unload_t0 = False
#~# unload_t1 = False
#~# _timelapse_new_frame = False
#~# _set_timelapse_setup = False
#~# timelapse_take_frame = False
#~# wipe = False
#~# _unload_t0 = False
#~# _unload_t1 = False
#~# test_stream_delay = False
#~# _runout_detected = False
#~# _swapto_t0 = False
#~# _swapto_t1 = False
#~# _unload_extruder = False
#~#