You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The spreadsheet describes three pad modes that may be selected by sending CC 3 to the control port. I found a few more.
Value 7 gives a row of toggle buttons, sending CC value 127 when pressed then value 0 when pressed again plus a row of press to hold that send value 127 when pressed and 0 when released.
Value 8 gives a program change selector with 16 mutually exclusive buttons. When one is pressed it selects that button, deselects all other buttons and sends a program change 1-16 depending on which button is pressed.
Both of these send messages to MIDI port 1.
Having selected one of these, it becomes the Custom layout availabe from the Shift+Custom key combination. I haven't checked all values so there may be more. These were available after updating firmware to 1.1. I did not check with firmware 1.01.
The text was updated successfully, but these errors were encountered:
Really nice discovery! Looks like it's some undocumented, maybe work in progress features?
Found one more, value 6 gives you something similar to drum mode, but notes are in ascending from bottom left to top right corner.
I will add these to README and spreadsheet.
The spreadsheet describes three pad modes that may be selected by sending CC 3 to the control port. I found a few more.
Value 7 gives a row of toggle buttons, sending CC value 127 when pressed then value 0 when pressed again plus a row of press to hold that send value 127 when pressed and 0 when released.
Value 8 gives a program change selector with 16 mutually exclusive buttons. When one is pressed it selects that button, deselects all other buttons and sends a program change 1-16 depending on which button is pressed.
Both of these send messages to MIDI port 1.
Having selected one of these, it becomes the Custom layout availabe from the Shift+Custom key combination. I haven't checked all values so there may be more. These were available after updating firmware to 1.1. I did not check with firmware 1.01.
The text was updated successfully, but these errors were encountered: