TODO.md

TODO.md

Electrics/Mechanical

• Voron Tap
• Euclid probe arm with magnet in it.
• electronics bay cover
• re-design the VOC filter
• Convert to CAN bus board on the toolhead. Pending: a canbus board with 24v stepper driver and 12v fans
• Single MGN X rail
• Voron 2.4 GE5C Z joint - https://github.com/hartk1213/MISC/tree/main/Voron%20Mods/Voron%202/2.4/Voron2.4_GE5C
• Improved Y tension blocks
• weaker door latches
• Stealthburner
• E3D Revo

Printer Tuning

• Pressure Advance Tuning: https://www.klipper3d.org/Pressure_Advance.html
• Resonance Compensation: https://www.klipper3d.org/Resonance_Compensation.html
• Add an intro line/purge line to start the print
• Fame thermal compensation

Software

• 1st layer tuning print macro
• Pressure advance tuning macro
• Part cooling fan override module, make part cooling fan run faster or slower during print time.
  • print is ruined because of not enough cooling.
  • print is ruined because of too much cooling.
  • print is ruined because of intermittent cooling (fan too low or off) that should be constant.
• WAIT_THERMAL_EQUILIBRIUM
• Build Sheet Manager