Psa home assistant sensors

[Stealth100]

Hi all I have the psa controller running on raspberry pi and it shows everything, trips, battery etc. But all sensors in home assistant are unavailable is there a possible fix please?

[RGx01]

Try this adding this config. https://www.speaktothegeek.co.uk/2023/03/using-home-assistant-to-control-your-vauxhall-peugeot-or-citroen-car/#configure-sensors

[Stealth100]

Try this adding this config. https://www.speaktothegeek.co.uk/2023/03/using-home-assistant-to-control-your-vauxhall-peugeot-or-citroen-car/#configure-sensors

Tried that one along with many others. The psa addon works and shows all info but the ha never shows any sensors available

[kurim]

Alternative use Node-Red to expose the sensors, this works very good.

[JS-Lorthe]

@kurim Waouh, great idea! Could you please give some details about this method? I'm not very familiar with Node Red.

Thank you!!

[kurim]

You need Node-Red as an Addon and Node-RED Companion Integration from HACS.
Now you need to run Nod-Red Addon and add Node-Red as Integration.

Then open NodeRed:

and load the flow (notice settings are in german, so you need to change them, also need to change IP + adding YOURVIN

flows.json

[JS-Lorthe]

Hello,
Thank you very much @kurim , I have imported the json file but I have an issue. I think it's about the IP. I have used 127.0.0.1:5000 (by default) but I have this issue below. Have you an idea about that?

Thank you again

And the detail of my IP

[kurim]

Can you test the homeassistant ip + 5000 in browser?
If not you need to set the port in addon config.

example:

[JS-Lorthe]

Hello Kurim,
I have restart from scratch and I have change the port 5000=>9000. and now it work!! Thank you very much!!