diff --git a/target/linux/mediatek/dts/mt7981b-abt-asr3000.dts b/target/linux/mediatek/dts/mt7981b-abt-asr3000.dts new file mode 100644 index 00000000000000..b089f3d274fda4 --- /dev/null +++ b/target/linux/mediatek/dts/mt7981b-abt-asr3000.dts @@ -0,0 +1,255 @@ +// SPDX-License-Identifier: GPL-2.0-or-later OR MIT + +/dts-v1/; +#include +#include + +#include "mt7981.dtsi" + +/ { + model = "ABT ASR3000"; + compatible = "abt,asr3000", "mediatek,mt7981"; + + aliases { + serial0 = &uart0; + led-boot = &led_wps; + led-upgrade = &led_wps; + label-mac-device = &gmac0; + }; + + chosen { + stdout-path = "serial0:115200n8"; + }; + + memory { + reg = <0 0x40000000 0 0x10000000>; + }; + + gpio-keys { + compatible = "gpio-keys"; + + reset { + label = "reset"; + linux,code = ; + gpios = <&pio 1 GPIO_ACTIVE_LOW>; + }; + + mesh { + label = "mesh"; + linux,code = ; + gpios = <&pio 0 GPIO_ACTIVE_HIGH>; + }; + }; + + leds { + compatible = "gpio-leds"; + + wan { + label = "green:wan"; + gpios = <&pio 8 GPIO_ACTIVE_LOW>; + }; + + led_wps: wps { + label = "green:wps"; + gpios = <&pio 15 GPIO_ACTIVE_HIGH>; + }; + }; +}; + +ð { + status = "okay"; + + gmac0: mac@0 { + compatible = "mediatek,eth-mac"; + reg = <0>; + phy-mode = "2500base-x"; + + nvmem-cells = <&macaddr_art_0>; + nvmem-cell-names = "mac-address"; + + fixed-link { + speed = <2500>; + full-duplex; + pause; + }; + }; + + gmac1: mac@1 { + compatible = "mediatek,eth-mac"; + reg = <1>; + phy-mode = "gmii"; + phy-handle = <&int_gbe_phy>; + + nvmem-cells = <&macaddr_art_0>; + nvmem-cell-names = "mac-address"; + mac-address-increment = <0x500000>; + }; +}; + +&mdio_bus { + switch: switch@0 { + compatible = "mediatek,mt7531"; + reg = <31>; + reset-gpios = <&pio 39 GPIO_ACTIVE_HIGH>; + interrupt-controller; + #interrupt-cells = <1>; + interrupt-parent = <&pio>; + interrupts = <38 IRQ_TYPE_LEVEL_HIGH>; + }; +}; + +&spi0 { + pinctrl-names = "default"; + pinctrl-0 = <&spi0_flash_pins>; + status = "okay"; + + spi_nand@0 { + compatible = "spi-nand"; + #address-cells = <1>; + #size-cells = <1>; + reg = <0>; + + spi-max-frequency = <52000000>; + spi-tx-bus-width = <4>; + spi-rx-bus-width = <4>; + + mediatek,nmbm; + mediatek,bmt-max-ratio = <1>; + mediatek,bmt-max-reserved-blocks = <64>; + + partitions { + compatible = "fixed-partitions"; + #address-cells = <1>; + #size-cells = <1>; + + partition@0 { + label = "BL2"; + reg = <0x0000000 0x0100000>; + read-only; + }; + + partition@100000 { + label = "u-boot-env"; + reg = <0x0100000 0x0080000>; + }; + + partition@180000 { + label = "art"; + reg = <0x0180000 0x0100000>; + read-only; + + compatible = "nvmem-cells"; + #address-cells = <1>; + #size-cells = <1>; + + macaddr_art_0: macaddr@0 { + reg = <0x0 0x6>; + }; + + macaddr_art_6: macaddr@6 { + reg = <0x6 0x6>; + }; + }; + + factory: partition@280000 { + label = "Factory"; + reg = <0x0280000 0x0100000>; + read-only; + }; + + partition@380000 { + label = "FIP"; + reg = <0x0380000 0x0200000>; + read-only; + }; + + partition@580000 { + label = "ubi"; + reg = <0x0580000 0x7000000>; + }; + }; + }; +}; + +&switch { + ports { + #address-cells = <1>; + #size-cells = <0>; + + port@0 { + reg = <0>; + label = "lan3"; + }; + + port@1 { + reg = <1>; + label = "lan2"; + }; + + port@2 { + reg = <2>; + label = "lan1"; + }; + + port@6 { + reg = <6>; + label = "cpu"; + ethernet = <&gmac0>; + phy-mode = "2500base-x"; + + fixed-link { + speed = <2500>; + full-duplex; + pause; + }; + }; + }; +}; + +&pio { + spi0_flash_pins: spi0-pins { + mux { + function = "spi"; + groups = "spi0", "spi0_wp_hold"; + }; + + conf-pu { + pins = "SPI0_CS", "SPI0_HOLD", "SPI0_WP"; + drive-strength = <8>; + mediatek,pull-up-adv = <0>; /* bias-disable */ + }; + + conf-pd { + pins = "SPI0_CLK", "SPI0_MOSI", "SPI0_MISO"; + drive-strength = <8>; + mediatek,pull-up-adv = <0>; /* bias-disable */ + }; + }; + + wf_led_pins: wf-led-pins { + mux { + function = "led"; + groups = "wf2g_led1", "wf5g_led1"; + }; + }; +}; + +&uart0 { + status = "okay"; +}; + +&watchdog { + status = "okay"; +}; + +&wifi { + status = "okay"; + pinctrl-0 = <&wifi_dbdc_pins>, <&wf_led_pins>; + nvmem-cells = <&macaddr_art_6>; + nvmem-cell-names = "mac-address"; + mediatek,mtd-eeprom = <&factory 0x0>; + + led { + led-active-low; + }; +}; diff --git a/target/linux/mediatek/filogic/base-files/etc/board.d/01_leds b/target/linux/mediatek/filogic/base-files/etc/board.d/01_leds index 5444f4586a2a87..45597c35cc86ac 100644 --- a/target/linux/mediatek/filogic/base-files/etc/board.d/01_leds +++ b/target/linux/mediatek/filogic/base-files/etc/board.d/01_leds @@ -6,6 +6,9 @@ board=$(board_name) board_config_update case $board in +abt,asr3000) + ucidef_set_led_netdev "wan" "WAN" "green:wan" "eth1" + ;; imou,lc-hx3001) ucidef_set_led_netdev "lan" "LAN" "green:lan" "br-lan" ucidef_set_led_netdev "wan" "WAN" "green:wan" "eth1" diff --git a/target/linux/mediatek/filogic/base-files/etc/board.d/02_network b/target/linux/mediatek/filogic/base-files/etc/board.d/02_network index 7e58f32c841730..a2854681d7d155 100644 --- a/target/linux/mediatek/filogic/base-files/etc/board.d/02_network +++ b/target/linux/mediatek/filogic/base-files/etc/board.d/02_network @@ -8,6 +8,11 @@ mediatek_setup_interfaces() local board="$1" case $board in + abt,asr3000|\ + h3c,magic-nx30-pro|\ + imou,lc-hx3001) + ucidef_set_interfaces_lan_wan "lan1 lan2 lan3" eth1 + ;; asus,tuf-ax4200|\ jdcloud,re-cs-05|\ netcore,n60|\ @@ -27,10 +32,6 @@ mediatek_setup_interfaces() glinet,gl-mt3000) ucidef_set_interfaces_lan_wan eth1 eth0 ;; - h3c,magic-nx30-pro|\ - imou,lc-hx3001) - ucidef_set_interfaces_lan_wan "lan1 lan2 lan3" eth1 - ;; mediatek,mt7986a-rfb|\ mediatek,mt7986b-rfb) ucidef_set_interfaces_lan_wan "lan0 lan1 lan2 lan3" eth1 diff --git a/target/linux/mediatek/filogic/base-files/etc/hotplug.d/ieee80211/11_fix_wifi_mac b/target/linux/mediatek/filogic/base-files/etc/hotplug.d/ieee80211/11_fix_wifi_mac index bb5dd48feee6d3..567491b9017633 100644 --- a/target/linux/mediatek/filogic/base-files/etc/hotplug.d/ieee80211/11_fix_wifi_mac +++ b/target/linux/mediatek/filogic/base-files/etc/hotplug.d/ieee80211/11_fix_wifi_mac @@ -10,6 +10,11 @@ PHYNBR=${DEVPATH##*/phy} board=$(board_name) case "$board" in + abt,asr3000) + addr=$(mtd_get_mac_binary "art" 0x6) + [ "$PHYNBR" = "1" ] && \ + macaddr_setbit_la "$(macaddr_add $addr 0x600000)" > /sys${DEVPATH}/macaddress + ;; asus,tuf-ax4200) CI_UBIPART="UBI_DEV" addr=$(mtd_get_mac_binary_ubi "Factory" 0x4) diff --git a/target/linux/mediatek/image/filogic.mk b/target/linux/mediatek/image/filogic.mk index 1a5efa06231895..07f9b145187bf4 100644 --- a/target/linux/mediatek/image/filogic.mk +++ b/target/linux/mediatek/image/filogic.mk @@ -51,6 +51,20 @@ define Build/cetron-header rm $@.tmp endef +define Device/abt_asr3000 + DEVICE_VENDOR := ABT + DEVICE_MODEL := ASR3000 + DEVICE_DTS := mt7981b-abt-asr3000 + DEVICE_DTS_DIR := ../dts + UBINIZE_OPTS := -E 5 + BLOCKSIZE := 128k + PAGESIZE := 2048 + KERNEL_IN_UBI := 1 + DEVICE_PACKAGES := kmod-mt7981-firmware mt7981-wo-firmware + IMAGE/sysupgrade.bin := sysupgrade-tar | append-metadata +endef +TARGET_DEVICES += abt_asr3000 + define Device/asus_tuf-ax4200 DEVICE_VENDOR := ASUS DEVICE_MODEL := TUF-AX4200