You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm facing an issue with BLTouch/CRTouch on my SKR E3 Turbo converted Ender3.
It's actually very similar issue as what's reported on SKR Mini E3. (bigtreetech/BIGTREETECH-SKR-mini-E3#311)
Description
On the printer itself:
When choosing "Level Bed" from menu, theprints starts probing but after the first probing, it freezes and the printer display shows M112 Shutdown PRINTER HALTED Please Reset.
On octoprint:
The same issue happens when initiating bed leving using Bed Visualizer.
I'm facing an issue with BLTouch/CRTouch on my SKR E3 Turbo converted Ender3.
It's actually very similar issue as what's reported on SKR Mini E3. (bigtreetech/BIGTREETECH-SKR-mini-E3#311)
Description
On the printer itself:
When choosing "Level Bed" from menu, theprints starts probing but after the first probing, it freezes and the printer display shows
M112 Shutdown PRINTER HALTED Please Reset.
On octoprint:
The same issue happens when initiating bed leving using Bed Visualizer.
Steps to reproduce
Z-PROVE
connector of the boardfirmware-bltouch.bi
Expected behavior
Bed levveling success. Mesh updated and setting stored.
Actual behavior
Printer freezes and the display shows the error above.
Additional Information
Board: BTT SKR E3 Turbo
Z-Probe: CR Touch
I compiled Marlin based on 2.0.92, but am facing another issues around BLTouch.
The text was updated successfully, but these errors were encountered: