You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
IRX6 is a multi-protocol module, which plugs into the trainer port, reads the PPM signal, and lets you control various toy quads. In order to select the protocol one needs to provide an appropriate gesture when powering up the module (e.g. "aileron up" would enable one protocol, "rudder right + aileron left@ another one, etc).
It seems that with the new firmware the IRX6 stops recognizing any protocols which have the rudder involved in their switch-on gesture.
Does anyone know the reason for this behaviour and a possible way of fixing it?
The text was updated successfully, but these errors were encountered:
IRX6 is a multi-protocol module, which plugs into the trainer port, reads the PPM signal, and lets you control various toy quads. In order to select the protocol one needs to provide an appropriate gesture when powering up the module (e.g. "aileron up" would enable one protocol, "rudder right + aileron left@ another one, etc).
It seems that with the new firmware the IRX6 stops recognizing any protocols which have the rudder involved in their switch-on gesture.
Does anyone know the reason for this behaviour and a possible way of fixing it?
The text was updated successfully, but these errors were encountered: