Tasmota Timer Problem. Auto unchecking enable?

[CyprusWildlife]

Hello,
I have recently just set up a simple system with BlitzWolf SHP with Tasmota 14.3.0. All I need is to turn on the power at 6am, and turn it off at 23:45. I have configured wifi, my ntp server and enabled 1 and 2 under configure timer for on and off and it works.

Problem is, every once in a while, it stops working and when I log in to Configure Timer, I see my rules are not enabled anymore. I did a bit of research and already used setoption65 to OFF and setoption36 to 0 but cannot figure out what else may be causing this.

I am currently at a loss to figure out what's causing my timer enable checkbox to go unchecked on their own. Sometimes its one of them, sometimes its both, and I do not seem to be losing any other config. Any ideas?

[barbudor]

I can't see any obvious reason for such behavior
I would advise you setup a syslog receiver to store logs for a long time and enable a level 3 loglevel