7.4.4 (Software power button and CLI enhancement).

[T-Troll]

Important! If you are using tools for the first time, please read Beginner's guide and AlienFX-GUI readme to configure out it's concept and operation principle.

Changes into this release:

All light-control tools:

• Device status check before start update for APIv4 (this help to avoid light update delay for rapid updates).
• Bug fixed: Light colors not stored into device for APIv4.

All fan-control tools:

• Bug fixed: G-mode set/reset/restored incorrectly for Dell G5-5510 in some cases.

AlienFan-GUI:

• Bug fixed: Application crashed then quit/sleep/hibernate in some cases (incorrect power mode stored).
• Bug fixed: "G-Mode" checkbox active for unsupported systems.

AlienFX-GUI:

• "Power button" software effect now react on battery charge (blink between selected colors) and low battery level (blink between battery color and black).
• Application quit and system sleep/hibernate accelerated greatly for APIv4 devices.
• Light device connect/disconnect detection optimized to not interfere with main light changes.
• Bug fixed: Light system status can have incorrect state before/after sleep/hibernate/monitor state change.
• Bug fixed: Light updates slow down in some cases after one of the light devices disconnected (or not connected).
• Bug fixed: "Blink" events do it so fast in some cases.

AlienFX-CLI:

• set-dim command now can have 1 or 2 parameters - if only one supplied, it set all devices/lights brightness (hardware for low-level, software for high-level).
• lightson and lightsoff commands removed - use set-dim=255 or set-dim=0 instead.
• reset command removed as useless.

---

This discussion was created from the release 7.4.4 (Software power button and CLI enhancement)..