VPN Director
VPN Director lets you create rules to determine how your LAN traffic is redirected through your OpenVPN and WireGuard clients. You can create rules based on their local or remote IP (or even both). Subnets in CIDR notation (i.e. 192.168.50.0/24) can also be used to cover IP ranges.
Introduced in version 386.3, this replaces the previous Policy Rules implementation by a global configuration where rules can be centrally managed instead of having to edit them for each individual client.
People who had Policy Rules configured in previous firmware releases will automatically have these migrated to VPN Director. You might need to review them as you might have some duplicate WAN entries if they existed on multiple clients. Policy Rule and Policy Rule (strict) modes will automatically be switched to VPN Director mode.
Note that the VPN Director interface may be slightly different under older firmware versions. The documentation here specifically targets the implementation from 388.1. Older versions will lack buttons to edit a client, for example.
If configuring a rule for an OpenVPN client, make sure that client is configured for "VPN Director" in its routing mode. WireGuard clients will always use VPN Director rules (there is no configurable route mode for them).
On the VPN Director page you can create rules, by selecting the local and remote IPs (these are optional, you can leave one of the fields empty to indicate "any IP"), as well as the destination (either WAN to bypass all VPN tunnels, or one of the five OpenVPN/WireGuard clients). You can also enter a short description to identify that rule on the web interface.
On the main list, rules can be enabled/disabled by clicking on the icon in the leftmost column.
After making any change, don't forget to apply these changes by clicking on the Apply button at the bottom. Rules will be immediately applied without having to restart running clients.
Up to a maximum of 199 rules can be created in total (that maximum can be lower if you use very long descriptions, as the total rules length must not exceed 7999 characters).
Rules are applied in the following order, with the first matching rule getting used:
- Rules with a WAN destination
- Rules with an OpenVPN 1 destination
- Rules with an OpenVPN 2 destination
- ...
- Rules with an OpenVPN 5 destination
- Rules with a WireGuard 1 destination
- Rules with a WireGuard 2 destination
- ...
- Rules with a WireGuard 5 destination
Also note that any routes configured on the Dual WAN page will have a higher priority than all of these.
- You can start/stop clients on the VPN Director page by clicking on the stop/start icon under the Enable column in the client status tables. (don't forget to Apply your VPN Director changes first)
- You can edit a client configuration by clicking on its icon under the Edit column. (don't forget to Apply your VPN Director changes first)
- Clients affected by DNS Exclusive mode are also prioritized (so if a client is affected by DNS Exclusive mode, it will be applied even if a later client rule would make it not Exclusive)
- Keep in mind that the killswitch will affect how lower priority clients work. If a higher priority client triggers its killswitch, then no traffic will go through the lower priority clients. You will generally want your lowest priority client to use the killswitch if you use multiple clients.
- VPN Director rules are stored in the /jffs partition rather than in nvram (due to their size), in the same directory that contains OpenVPN keys and certificates.
- In previous versions of the firmware before the VPN Director existed, Remote IP could be set to 0.0.0.0 for policy rules. However, with VPN Director, the Remote IP should be left blank if the intention is to specify any or all IP addresses. If not, there could be issues with the kill switch not behaving as expected.