You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I've been trying to put together Boop Beta 4 but trying to follow the Tap manual doesn't help since there are enough differences between Boop Beta 4 and current version of Tap I am not sure how to assemble Boop.
For exampleL for the 50mm rail the tap manual has the middle bolt as M3x8 and the bottom bolt as M3x12. With Boop Beta 4 those are too short (unless I am doing something wrong as I have the heat inserts as far in as I can get them to go). I had to use an M3x12 for the middle bolt and M3x16 for the bottom. Correct if this is incorrect.
Also I have no idea where the remaining 7 heat inserts go.
I cannot use Fusion 360 to load the CAD file as it doesn't have a dark mode (as far as I can tell) and I cannot read the interface at all in light mode until I have eye surgery.
The text was updated successfully, but these errors were encountered:
I've been trying to put together Boop Beta 4 but trying to follow the Tap manual doesn't help since there are enough differences between Boop Beta 4 and current version of Tap I am not sure how to assemble Boop.
For exampleL for the 50mm rail the tap manual has the middle bolt as M3x8 and the bottom bolt as M3x12. With Boop Beta 4 those are too short (unless I am doing something wrong as I have the heat inserts as far in as I can get them to go). I had to use an M3x12 for the middle bolt and M3x16 for the bottom. Correct if this is incorrect.
Also I have no idea where the remaining 7 heat inserts go.
I cannot use Fusion 360 to load the CAD file as it doesn't have a dark mode (as far as I can tell) and I cannot read the interface at all in light mode until I have eye surgery.
The text was updated successfully, but these errors were encountered: