Neotron-BMC-Nucleo

Introduction

This folder is for the Board Management Controller (BMC) when running on an STM32F4 Nucleo board.

This firmware runs on an ST Nucleo-F401RE, for development and debugging purposes. The STM32F401RET6U MCU has:

CPU Pin	Nucleo-64 Pin	Name	Signal	Function
2	CN7 23	PC13	BUTTON_nPWR	Power Button Input (active low)
33	CN10 16	PB12	BUTTON_nRST	Reset Button Input (active low)
34	CN10 30	PB13	MON_3V3	3.3V rail monitor Input (1.65V nominal)
35	CN10 28	PB14	MON_5V	5.0V rail monitor Input (1.65V nominal)
36	CN10 26	PB15	nSYS_RESET	System Reset Output (active low)
8	CN8 6	PC0	DC_ON	PSU Enable Output (active high)
20	CN8 3	PA4	SPI1_NSS	SPI Chip Select Input (active low) ??
21	CN5 6	PA5	SPI1_SCK	SPI Clock Input
22	CN5 5	PA6	SPI1_MISO	SPI Data Output
23	CN5 4	PA7	SPI1_MOSI	SPI Data Input
9	CN6 5	PC1	POWER_LED	Output for Power LED
10	CN7 35	PC2	STATUS_LED	Output for Status LED
11	CN7 37	PC3	IRQ_nHOST	Interrupt Output to the Host (active low)
42	CN10 21	PA9	USART1_TX	UART Transmit Output
43	CN10 33	PA10	USART1_RX	UART Receive Input
44	CN10 14	PA11	USART1_CTS	UART Clear-to-Send Output
45	CN10 12	PA12	USART1_RTS	UART Ready-to-Receive Input
46	CN7 13	PA13	SWDIO	SWD Progamming Data Input
49	CN7 15	PA14	SWCLK	SWD Programming Clock Input
25	CN10 6	PC5	PS2_CLK0	Keyboard Clock Input
26	CN8 4	PB0	PS2_CLK1	Mouse Clock Input
27	CN10 24	PB1	PS2_DAT0	Keyboard Data Input
28	CN10 22	PB2	PS2_DAT1	Mouse Data Input
58	CN10 17	PB6	I2C1_SCL	I²C Clock
59	CN7 21	PB7	I2C1_SDA	I²C Data

rustup and Rust
- see https://www.rust-lang.org
The thumbv7em-none-eabi target
- run rustup target add target=thumbv7em-none-eabi
probe-run
- run cargo install probe-run from your $HOME dir (not this folder!)
flip-link
- run cargo install flip-link from your $HOME dir (not this folder!)

Then to build and flash, connect a probe supported by probe-rs (such as a SEGGER J-Link, or an ST-Link) and run:

$ cargo run --release