[BUG] E steps settings only in hundreds

[kihope]

When i want set esteps in LCD only values are 0 - 100 - 200 - 300 etc, my board is skr 1.3

[macasero]

same here, also Initialitate eprom, doesn´t seam to work fine.

Pronterface M92 setting, M500 and M503 shows correct steps, but lcd settings only show units and set to hundreds

[shitcreek]

What version of Marlin are y'all using? Please provide more information.

[kihope]

I have Marlin 2, i downloaded about day ago when i was updating the printer

[shitcreek]

Could you provide your configs? What happens when you turn the dial fast vs slow?

[kihope]

https://github.com/kihope/TevoTrantula_Marlin-2.0_SKR_v1_3/blob/master/Configuration.h

Dont mind the mess please, i can change steps in config, however when i go to lcd all goes by hundred, so i even cant get the values i had before back, before step were able se by tenths if i remember now only by hundreds (as i mentioned: 0,100,200,nnn.. way up) i dont think it is caused by my config..

[shitcreek]

I don't see anything out of place in your config.
Are you using JimBrown's easyConfig 2.0 or Marlin bugfix 2.0?

[tpruvot]

see e7b3720 for a possible way to fix that. btw the default config for Z and E steps are incredibly huge imo

[MasterTim17]

I reverted this commit 2d98bb but havent tried it since then again

[github-actions]

This issue has been automatically locked since there has not been any recent activity after it was closed. Please open a new issue for related bugs.