-
Notifications
You must be signed in to change notification settings - Fork 26
Compatibility
Yurii edited this page Nov 12, 2024
·
60 revisions
| Boiler | Master Member ID | Required settings | Notes |
|---|---|---|---|
| Baxi ECO Nova | default | Coeff. DHW flow rate correction = 0.1 | Pressure sensor not supported |
| BAXI LUNA Duo-tec E 24 | default | - | Heating does not switch off with parameter P67=02 in the boiler service menu |
| Baxi AMPERA | 4 | Modulation sync with heating = on | Pressure sensor not supported, only heating DHW not tested |
| Baxi NUVOLA Duo-tec HT 16 | default | default | - |
| Baxi LUNA-3 | default | default | - |
| Baxi Duo-tec Compact 24 | default | default | - |
| Baxi ECO Four 24 F | default | default | - |
| Baxi LUNA-3 COMFORT | default | DHW present = on Duplicate DHW to CH2 = on |
- |
| Baxi ECO Life 1.24 F | default | default | - |
| Baxi ECO-4s 1 2 | default | default | DHW flow rate not supported Set max modulation level not supported |
| Baxi Eco 5 Compact | default | default | Pressure sensor not supported |
| Boiler | Master Member ID | Required settings | Notes |
|---|---|---|---|
|
Ferroli DOMIcompact C 24 Board: MF08FA |
211 | default | Pressure sensor not supported |
| Ferroli Kalis 24C | default | default | - |
| Ferroli Atlas D Unit 30 | default | default | - |
| Ferroli Divatech D C24 | default | Summer/winter mode = on | Modulation level not supported |
| Ferroli Bluehelix Hitech RRT 28C | default | default | - |
| Boiler | Master Member ID | Required settings | Notes |
|---|---|---|---|
| Ideal Logic C30 | default | default | Set max modulation level not supported Exhaust temp & pressure sensor not supported |
| Ideal Vogue Max 32 | default | default | - |
| Ideal Logic Heat2 H18 | default | default | Only the following parameters are supported: - Flame - Fault and diagnostic along with codes - Modulation - Flow and return temperature The boiler's physical temperature control must be set to at least the maximum expected to be set by OpenTherm, acting as a hard limit on the OpenTherm requests |
| Boiler | Master Member ID | Required settings | Notes |
|---|---|---|---|
| Immergas Nike Mythos 24 | default | Fix for Immergas boilers = on | ? |
| Immergas Victrix Zeus 25 | default | Fix for Immergas boilers = on | DHW flow rate sensor not supported |
| Boiler | Master Member ID | Required settings | Notes |
|---|---|---|---|
| Remeha Calenta Ace 40C | default | default | - |
| AEG GBA124 | default | default | Pressure sensor not supported |
| Termet Ecocondens Silver 35kW | default | default | Pressure sensor not supported |
| ITALTHERM TIME MAX 30F | default | Summer/winter mode = on | Pressure sensor not supported |
| Viessmann Vitodens 0-50w | default | default | - |
| Radiant R2KA | default | Modulation sync with heating = off | Pressure sensor not supported DHW flow rate sensor not supported |
| Intergas Kombi Kompakt | default | default | - |
| Baltur Tesis 24 | default | default | - |
| Navien NCB700 | default | default | - |
| Nova Florida Delfis CTFS 24 | default | default | - |
| Buderus U072 | default | default | - |
| Bosch wbn 6000-24 | default | default | - |
| Mizudo M24TH | default | default | - |
| Rinnai M060SN | default | Get min/max temp from boiler = off | - |
| De Dietrich PMC-M 24/28MI PLUS | 11 | Summer/winter mode = on Heating CH2 always enabled = off |
Pressure sensor not supported DHW flow rate sensor not supported Exhaust temp sensor not supported |
| Termet Gold Plus 2 | default | default | DHW switch off does not work |
| De Dietrich MS 24 FF | default | default | Fault code not supported Diagnostic status is always on |
| Vaillant hrSOLIDE VHR NL 18-22C | default | default | Pressure sensor not supported |
| Board | Chip | Flash | Recommended GPIOs | Where buy |
|---|---|---|---|---|
| Wemos D1 mini | ESP-8266EX | 4MB | Status LED: 13 OT In: 4 OT Out: 5 OT RX LED: 15 Outdoor sensor: 12 Indoor sensor: 14 |
Aliexpress |
| Wemos D1 mini pro | ESP-8266EX | 16MB | Status LED: 13 OT In: 4 OT Out: 5 OT RX LED: 15 Outdoor sensor: 12 Indoor sensor: 14 |
Aliexpress |
| Wemos D1 mini lite | ESP-8285 | 1MB | Status LED: 13 OT In: 4 OT Out: 5 OT RX LED: 15 Outdoor sensor: 12 Indoor sensor: 14 |
Aliexpress |
| NodeMCU V3 | ESP-8266 | 4MB | Status LED: 2 OT In: 13 OT Out: 15 OT RX LED: 16 Outdoor sensor: 12 Indoor sensor: 4 |
Aliexpress |
| Wemos S2 mini | ESP32-S2FN4R2 | 4MB | Status LED: 11 OT In: 33 OT Out: 35 OT RX LED: 12 Outdoor sensor: 9 Indoor sensor: 7 |
Aliexpress |
| Wemos S3 mini | ESP32-S3FH4R2 | 4MB | Status LED: 11 OT In: 35 OT Out: 36 OT RX LED: 10 Outdoor sensor: 13 Indoor sensor: 12 |
Aliexpress |
| Wemos C3 mini | ESP32-C3FH4 | 4MB | Status LED: 4 OT In: 8 OT Out: 10 OT RX LED: 5 Outdoor sensor: 0 Indoor sensor: 1 |
Aliexpress |
| Wemos D1 mini 32 | ESP32-? | 4MB | Status LED: 2 OT In: 21 OT Out: 22 OT RX LED: 19 Outdoor sensor: 12 Indoor sensor: 18 |
Aliexpress |
| NodeMCU 32S | ESP32-? | 4MB | Status LED: 2 OT In: 16 OT Out: 4 OT RX LED: 19 Outdoor sensor: 15 Indoor sensor: 26 |
Aliexpress |
| Sensor | Tested | Where buy |
|---|---|---|
| DS18B20 | Yes | Aliexpress |
| DS1822 | No | ? |
| DS1820 | No | ? |
| MAX31820 | No | ? |
| MAX31850 | No | ? |