-
Notifications
You must be signed in to change notification settings - Fork 100
/
ELECHOUSE_CC1101_SRC_DRV.h
194 lines (186 loc) · 9.09 KB
/
ELECHOUSE_CC1101_SRC_DRV.h
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
/*
ELECHOUSE_CC1101.cpp - CC1101 module library
Copyright (c) 2010 Michael.
Author: Michael, <www.elechouse.com>
Version: November 12, 2010
This library is designed to use CC1101/CC1100 module on Arduino platform.
CC1101/CC1100 module is an useful wireless module.Using the functions of the
library, you can easily send and receive data by the CC1101/CC1100 module.
Just have fun!
For the details, please refer to the datasheet of CC1100/CC1101.
----------------------------------------------------------------------------------------------------------------
cc1101 Driver for RC Switch. Mod by Little Satan. With permission to modify and publish Wilson Shen (ELECHOUSE).
----------------------------------------------------------------------------------------------------------------
*/
#ifndef ELECHOUSE_CC1101_SRC_DRV_h
#define ELECHOUSE_CC1101_SRC_DRV_h
#include <Arduino.h>
//***************************************CC1101 define**************************************************//
// CC1101 CONFIG REGSITER
#define CC1101_IOCFG2 0x00 // GDO2 output pin configuration
#define CC1101_IOCFG1 0x01 // GDO1 output pin configuration
#define CC1101_IOCFG0 0x02 // GDO0 output pin configuration
#define CC1101_FIFOTHR 0x03 // RX FIFO and TX FIFO thresholds
#define CC1101_SYNC1 0x04 // Sync word, high INT8U
#define CC1101_SYNC0 0x05 // Sync word, low INT8U
#define CC1101_PKTLEN 0x06 // Packet length
#define CC1101_PKTCTRL1 0x07 // Packet automation control
#define CC1101_PKTCTRL0 0x08 // Packet automation control
#define CC1101_ADDR 0x09 // Device address
#define CC1101_CHANNR 0x0A // Channel number
#define CC1101_FSCTRL1 0x0B // Frequency synthesizer control
#define CC1101_FSCTRL0 0x0C // Frequency synthesizer control
#define CC1101_FREQ2 0x0D // Frequency control word, high INT8U
#define CC1101_FREQ1 0x0E // Frequency control word, middle INT8U
#define CC1101_FREQ0 0x0F // Frequency control word, low INT8U
#define CC1101_MDMCFG4 0x10 // Modem configuration
#define CC1101_MDMCFG3 0x11 // Modem configuration
#define CC1101_MDMCFG2 0x12 // Modem configuration
#define CC1101_MDMCFG1 0x13 // Modem configuration
#define CC1101_MDMCFG0 0x14 // Modem configuration
#define CC1101_DEVIATN 0x15 // Modem deviation setting
#define CC1101_MCSM2 0x16 // Main Radio Control State Machine configuration
#define CC1101_MCSM1 0x17 // Main Radio Control State Machine configuration
#define CC1101_MCSM0 0x18 // Main Radio Control State Machine configuration
#define CC1101_FOCCFG 0x19 // Frequency Offset Compensation configuration
#define CC1101_BSCFG 0x1A // Bit Synchronization configuration
#define CC1101_AGCCTRL2 0x1B // AGC control
#define CC1101_AGCCTRL1 0x1C // AGC control
#define CC1101_AGCCTRL0 0x1D // AGC control
#define CC1101_WOREVT1 0x1E // High INT8U Event 0 timeout
#define CC1101_WOREVT0 0x1F // Low INT8U Event 0 timeout
#define CC1101_WORCTRL 0x20 // Wake On Radio control
#define CC1101_FREND1 0x21 // Front end RX configuration
#define CC1101_FREND0 0x22 // Front end TX configuration
#define CC1101_FSCAL3 0x23 // Frequency synthesizer calibration
#define CC1101_FSCAL2 0x24 // Frequency synthesizer calibration
#define CC1101_FSCAL1 0x25 // Frequency synthesizer calibration
#define CC1101_FSCAL0 0x26 // Frequency synthesizer calibration
#define CC1101_RCCTRL1 0x27 // RC oscillator configuration
#define CC1101_RCCTRL0 0x28 // RC oscillator configuration
#define CC1101_FSTEST 0x29 // Frequency synthesizer calibration control
#define CC1101_PTEST 0x2A // Production test
#define CC1101_AGCTEST 0x2B // AGC test
#define CC1101_TEST2 0x2C // Various test settings
#define CC1101_TEST1 0x2D // Various test settings
#define CC1101_TEST0 0x2E // Various test settings
//CC1101 Strobe commands
#define CC1101_SRES 0x30 // Reset chip.
#define CC1101_SFSTXON 0x31 // Enable and calibrate frequency synthesizer (if MCSM0.FS_AUTOCAL=1).
// If in RX/TX: Go to a wait state where only the synthesizer is
// running (for quick RX / TX turnaround).
#define CC1101_SXOFF 0x32 // Turn off crystal oscillator.
#define CC1101_SCAL 0x33 // Calibrate frequency synthesizer and turn it off
// (enables quick start).
#define CC1101_SRX 0x34 // Enable RX. Perform calibration first if coming from IDLE and
// MCSM0.FS_AUTOCAL=1.
#define CC1101_STX 0x35 // In IDLE state: Enable TX. Perform calibration first if
// MCSM0.FS_AUTOCAL=1. If in RX state and CCA is enabled:
// Only go to TX if channel is clear.
#define CC1101_SIDLE 0x36 // Exit RX / TX, turn off frequency synthesizer and exit
// Wake-On-Radio mode if applicable.
#define CC1101_SAFC 0x37 // Perform AFC adjustment of the frequency synthesizer
#define CC1101_SWOR 0x38 // Start automatic RX polling sequence (Wake-on-Radio)
#define CC1101_SPWD 0x39 // Enter power down mode when CSn goes high.
#define CC1101_SFRX 0x3A // Flush the RX FIFO buffer.
#define CC1101_SFTX 0x3B // Flush the TX FIFO buffer.
#define CC1101_SWORRST 0x3C // Reset real time clock.
#define CC1101_SNOP 0x3D // No operation. May be used to pad strobe commands to two
// INT8Us for simpler software.
//CC1101 STATUS REGSITER
#define CC1101_PARTNUM 0x30
#define CC1101_VERSION 0x31
#define CC1101_FREQEST 0x32
#define CC1101_LQI 0x33
#define CC1101_RSSI 0x34
#define CC1101_MARCSTATE 0x35
#define CC1101_WORTIME1 0x36
#define CC1101_WORTIME0 0x37
#define CC1101_PKTSTATUS 0x38
#define CC1101_VCO_VC_DAC 0x39
#define CC1101_TXBYTES 0x3A
#define CC1101_RXBYTES 0x3B
//CC1101 PATABLE,TXFIFO,RXFIFO
#define CC1101_PATABLE 0x3E
#define CC1101_TXFIFO 0x3F
#define CC1101_RXFIFO 0x3F
//************************************* class **************************************************//
class ELECHOUSE_CC1101
{
private:
void SpiStart(void);
void SpiEnd(void);
void GDO_Set (void);
void GDO0_Set (void);
void Reset (void);
void setSpi(void);
void RegConfigSettings(void);
void Calibrate(void);
void Split_PKTCTRL0(void);
void Split_PKTCTRL1(void);
void Split_MDMCFG1(void);
void Split_MDMCFG2(void);
void Split_MDMCFG4(void);
public:
void Init(void);
byte SpiReadStatus(byte addr);
void setSpiPin(byte sck, byte miso, byte mosi, byte ss);
void addSpiPin(byte sck, byte miso, byte mosi, byte ss, byte modul);
void setGDO(byte gdo0, byte gdo2);
void setGDO0(byte gdo0);
void addGDO(byte gdo0, byte gdo2, byte modul);
void addGDO0(byte gdo0, byte modul);
void setModul(byte modul);
void setCCMode(bool s);
void setModulation(byte m);
void setPA(int p);
void setMHZ(float mhz);
void setChannel(byte chnl);
void setChsp(float f);
void setRxBW(float f);
void setDRate(float d);
void setDeviation(float d);
void SetTx(void);
void SetRx(void);
void SetTx(float mhz);
void SetRx(float mhz);
int getRssi(void);
byte getLqi(void);
void setSres(void);
void setSidle(void);
void goSleep(void);
void SendData(byte *txBuffer, byte size);
void SendData(char *txchar);
void SendData(byte *txBuffer, byte size, int t);
void SendData(char *txchar, int t);
byte CheckReceiveFlag(void);
byte ReceiveData(byte *rxBuffer);
bool CheckCRC(void);
void SpiStrobe(byte strobe);
void SpiWriteReg(byte addr, byte value);
void SpiWriteBurstReg(byte addr, byte *buffer, byte num);
byte SpiReadReg(byte addr);
void SpiReadBurstReg(byte addr, byte *buffer, byte num);
void setClb(byte b, byte s, byte e);
bool getCC1101(void);
byte getMode(void);
void setSyncWord(byte sh, byte sl);
void setAddr(byte v);
void setWhiteData(bool v);
void setPktFormat(byte v);
void setCrc(bool v);
void setLengthConfig(byte v);
void setPacketLength(byte v);
void setDcFilterOff(bool v);
void setManchester(bool v);
void setSyncMode(byte v);
void setFEC(bool v);
void setPRE(byte v);
void setPQT(byte v);
void setCRC_AF(bool v);
void setAppendStatus(bool v);
void setAdrChk(byte v);
bool CheckRxFifo(int t);
};
extern ELECHOUSE_CC1101 ELECHOUSE_cc1101;
#endif