-
Notifications
You must be signed in to change notification settings - Fork 3
/
installation-domains.conf
74 lines (61 loc) · 2.75 KB
/
installation-domains.conf
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
## Introduction
# This file is not installed by default because it must only be used
# by advanced users and mostly when they are compiling everything from
# source.
# To use this file, manually copy it into the same directory where the
# GNUstep.conf file is installed (by default, /etc/GNUstep/), then
# edit it to suit your installation tastes.
# This file can be used to change the default installation domains for
# GNUstep software. By default, everything is installed into the
# Local domain; this file allows you to customize the default
# installation domains and specify that some packages are to be
# installed by default into System (or Network, or User).
# The System domain is normally reserved for prebuilt packages, that
# is the components shipped with your GNUstep system. So if you're
# building everything from source yourself, the System domain would
# never be used. In that case, you can use this file to change the
# default installation domain for some GNUstep software, installing
# them into System (instead of Local) by default.
# This file only specifies the default; you can always install a
# specific piece of software into whatever domain you want by using
# GNUSTEP_INSTALLATION_DOMAIN as in 'make install
# GNUSTEP_INSTALLATION_DOMAIN=LOCAL'.
# This file is very dangerous for end-users since they might be
# overwriting their System installation if they compile and install
# source code downloaded from the internet (eg, if they're trying a
# new version of Gorm). Only advanced users should be using it.
# Please never ship this file to end-users. Packagers (people
# building ready-to-use GNUstep distributions to be distributed to
# end-users) must never distribute this file.
# If you are an end-user and have found this file shipped with your
# GNUstep distribution or gnustep-make binary package, this is a bug
# in your GNUstep distribution or package. Please complain to your
# packager and put <[email protected]> in Cc:.
## The actual file
# To be activated, an entry in this list must match the PACKAGE_NAME
# as defined in the GNUmakefile of the project. For example, Gorm's
# top-level GNUmakefile has the lines
#
# PACKAGE_NAME = gorm
# export PACKAGE_NAME
#
# so you can have it be installed into System by adding 'gorm'
# to the list.
#
# Please note that any project not explicitly listed here will be
# installed into Local by default.
GNUSTEP_PACKAGES_TO_INSTALL_INTO_SYSTEM_BY_DEFAULT = \
gnustep-objc \
gnustep-objc2 \
libobjc2 \
toydispatch \
gnustep-base \
gnustep-gui \
gnustep-back \
gorm \
ProjectCenter \
gworkspace \
SystemPreferences
GNUSTEP_PACKAGES_TO_INSTALL_INTO_LOCAL_BY_DEFAULT = \
GNUSTEP_PACKAGES_TO_INSTALL_INTO_NETWORK_BY_DEFAULT = \
GNUSTEP_PACKAGES_TO_INSTALL_INTO_USER_BY_DEFAULT = \