TDSR12 No RX Bat Telemetry

[airxplore]

FW 1.6
TD SR12 FW 3.01

After updating firmware in both TX & RX I have lost the RXBATT voltage sensor. Have re-installed firmware, done factory reset, discovered new sensors but still nothing.

Any suggestions.
Thanks

[SmartTommy]

TDSR12_3.0.1_RC2.zip

[3wintro]

After update from TD SR12 FW 3.01 same behavior. RXBATT voltage sensor lost. I tried the FW TDSR12_3.0.1_RC2.zip and it works as it should. Can I leave the FW on? or wait until an official version is released.

[SmartTommy]

After update from TD SR12 FW 3.01 same behavior. RXBATT voltage sensor lost. I tried the FW TDSR12_3.0.1_RC2.zip and it works as it should. Can I leave the FW on? or wait until an official version is released.

you can use the RC2 firmware, or download the release firmware tomorrow( will replace the old with the RC2)

[4qr1hu9n7]

Hello;
I have a TD-SR18 rx. Performed the mandatory update. Re registered rx okay. Rebound rx, okay.

RESULTS;
No telemetry.
NO responses from most of the channels. And those that do respond do so incorrectly!
Why am I not surprised!!

[SmartTommy]

Hello; I have a TD-SR18 rx. Performed the mandatory update. Re registered rx okay. Rebound rx, okay.

RESULTS; No telemetry. NO responses from most of the channels. And those that do respond do so incorrectly! Why am I not surprised!!

which Radio you used? X20PRO? X20RS? did you upgrade your radio to 1.6.0 and both your Tx and Rx to 3.0.1?

[airxplore]

TDSR12_3.0.1_RC2.zip

Can confirm that this has sorted the issue, works great thanks and have noticed its now in the downloads section of Ethos suite. Great work guys