Replies: 3 comments
-
What was the problem? Wrong firmware flashed? |
Beta Was this translation helpful? Give feedback.
-
Problem was as text below copied from RCGroups (see link https://www.rcgroups.com/forums/showpost.php?p=52191009&postcount=1894) ETHOS 1.5.0. Release https://www.rcgroups.com/forums/show...ostcount=28272 Alert: If your X18, X18S or X18SE bootloader is not Release 1.4.15 or newer make sure to flash the bootloader first before doing the 1.5.0. update. Older bootloaders are not compatible with 1.5.0. and if the firmware is flashed first the radio will not start.
If you do get is a situation where 1.5.0. got flashed before the bootloader was updated here is a way to recover [https://www.rcgroups.com/forums/show...postcount=1910](https://www.rcgroups.com/forums/showpost.php?p=52193291&postcount=1910) |
Beta Was this translation helpful? Give feedback.
-
I have a X18S purchased set/2023 that has been working perfectly until tomorrow morning. During the update a screen the message "your bootloader may not support autoswitching" came up. Then I tried to switch off the radio and nothing happened anymore. Radio locked and only the message usb connected appeared in the radio screen. I ended up disconnecting cables and removing the battery.
After this radio doesn't turn on anymore but I can turn the bootloader mode.
I tried to connect the radio to ethios suite and repeat de procedures but nothing happen. Radio is died...
Any help.
Ethios suite 1.5.6
Bootloader 1.4.3
Beta Was this translation helpful? Give feedback.
All reactions