-
Notifications
You must be signed in to change notification settings - Fork 5
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Unable to write tmc spi 'stepper_x' register GLOBALSCALER HELPPP!!! #2
Comments
You have to power 48V as well. Just jump 24V to both 48V and 24V rails. |
thank you! i thought i had updated this post i found this same coment somewhere like 20 mins after posting this orginaly. If i may ask where did you find this out? cause there documentation is garbage |
By fucking around with wires until it started working. |
Got the spi bus working: Klipper3d/klipper#6683 |
my pitbv2 is broken, thanks, long life and prosperity. |
I got the Fystec PITB with the 2 BIG 5160s can board, got it working on can and everything works, fans rgb leds and whatnot but get this eror message when trying to move the x or y (what im using them on) steppers, googling has been of no help. im still trying to rap my head around the spi/ ic2 bus and how it works, but has anyone else ran into this issue?
The text was updated successfully, but these errors were encountered: