If you are new to CM4 Maker Board and want to get started quickly, you are in the right place! Here you will find all the information you need to set up your hardware and software and start coding with the CM4 Maker Board.
You can visit Getting Started with CM4 Maker Board to learn more about it.
To get started, you will need the following hardware and software:
Hardware:
- CM4 Maker Board
- Rapberry Pi CM4 Lite or Rapberry Pi CM4 with eMMC
- USB-C Universal Power Adapter
- Grove - PIR Motion Sensor
- Analog Micro Servo
- DHT11 Sensor Module
Software:
Raspberry Pi OS with installed Python. If you want to know how to install the Raspberry Pi OS on the CM4 Maker Board, you can visit this tutorial on Boot up Raspberry Pi CM4 on CM4 Maker Board.
To have better explaination on these code and related tutorial you can visit all these lessons:
- Lesson 1 : Gpio, Grove Port & Maker Port
- Lesson 2 : Buzzer & Buttons
- Lesson 3 : Camera
- Lesson 4 : Setup Switch On/Off Button
- Lesson 5 : RTC
- Lesson 6 : Audio Jack
For more information on the CM4 Maker Board, check out the datasheet here:
CM4 Maker Board Datasheet
If you need further assistance, we welcome you to our technical forum or you can contact us through email [email protected] where our team will be happy to assist you.
Let's start building with CM4 Maker Board!