I'm confused about what i need to be learning prior to this section...

[element73]

I'm using a fork of Marlin I believe called mriscoc. I really like his firmware for the Ender 3 v2.

My problem is that I'm trying to follow your guide but it's asking for information I haven't even calibrated for yet. You have a calibration form under the section: https://ellis3dp.com/Print-Tuning-Guide/articles/pressure_linear_advance/pattern_method.html#pattern-method

At least 90% of this information is unknown to me. I feel like the order of your guide is incorrect. I'm new to "fully calibrating" the printer. I've calibrated several things and I enjoyed your misconception section as it enlighten me a bit. But I feel very lost as I'm trying to now figure out what is the best approach. I'm starting to note all the information I don't have and then I plan to visit the sections that allow me to calibrate for that information like "retraction" and then go back to your calibration form to fill it in.

I have no guidance right now, but I'm assuming this is what I must do.