Route audio output of SDR++ to other apps?

[pmaine]

I am running SDR++ on a Raspberry Pi 4B on the Raspian OS. How can I route the audio out of SDR++ into another app such as FLDIGI or QSSTV?

[starvald]

you can add a virtual sink to the /etc/pulse/default.pa config.
add to the end of the config.

load-module module-null-sink sink_name=VirtualSink1 sink_properties=device.description=VirtualSink1

save then reboot.

then install pavucontrol you can then set sdrpp audio and qsstv to the virtual sink.

you can add as many virtual sinks as you need.

[pmaine]

Hi Lee

I appreciate all of the assistance!

I followed your steps exactly and when I rebooted the menu bar at the top of the screen disappeared after I rebooted. I commented our your lines and rebooted and the menu reappeared. Any ideas?

[starvald]

very strange, pulseaudio shouldn't anything to do with the gui.

this is what i have at the end of my default.pa without issue.

# Added line for virtual sink
load-module module-null-sink sink_name=VirtualSink1 sink_properties=device.description=VirtualSink1
load-module module-null-sink sink_name=VirtualSink2 sink_properties=device.description=VirtualSink2
load-module module-null-sink sink_name=VirtualSink3 sink_properties=device.description=VirtualSink3
load-module module-null-sink sink_name=VirtualSink4 sink_properties=device.description=VirtualSink4

[pmaine]

Lee
I incorrectly added separate lines per your original post. I put the commands on one line. I next rebooted and the virtual device was added AND my menu is normal.

I can now route audio from SDR++ to QSSTV!

thanks again!

[shuyuan-liu]

For just routing the audio into other apps, I think pavucontrol will suffice. Open the program that is to receive audio (so that it shows up in pavucontrol), go to the Recording tab, and change the source to "Monitor of [whatever the Pi's audio output is named]". Make sure you have enabled audio output in raspi-config so that you do have an audio output device.

[pmaine]

It’s working now!
Thank you

[starvald]

For just routing the audio into other apps, I think pavucontrol will suffice. Open the program that is to receive audio (so that it shows up in pavucontrol), go to the Recording tab, and change the source to "Monitor of [whatever the Pi's audio output is named]". Make sure you have enabled audio output in raspi-config so that you do have an audio output device.

true, you don't need to add virtualsinks but it does mean you can route audio to apps without hearing it while still being able to hear a vfo you want to listen to.

[pmaine]

Hi Lee
I’m interested on how you use your virtual audio devices. I went ahead and added four virtual devices like you. Please share!

[starvald]

for the 20m band i usually have fldigi for psk, 2 for SSTV and either one for Olivia mode or ft8.
11m band js8call, ROS and SSTV.

[pmaine]

Git won't allow me to mark as answered.