Settings

As of the full release of WLED 0.5, the settings are split in 5 sub-pages. This page is meant to clarify the purpose of each setting.

WiFi Settings

This sub-page offers options to connect the ESP to different WiFi/WLAN devices.

Setting name	Value Range	Description
Network Name	String 0..32	The name (SSID) of your home WiFi
Network password	String 0..64	The password of your home WiFi
Static IP	4x 0..256	An optional static IPv4 address
Static gateway	4x 0..255	In a static config, your gateway's IPv4 address
Static subnet	4x 0..255	In a static config, this normally is 255.255.255.0
mDNS address	String 0..32	Name of your device for the Bonjour/Zeroconf protocol
Try connecting...	0..255	How many seconds to try at boot to connect to home WiFi
Client IP	-	The current IP of the ESP in the home network
AP SSID	String 0..32	The name of the ESPs internal WiFi hotspot (Access Point)
Hide AP name	Y/N	The ESPs Access Point won't appear in WiFi lists of other devices
AP password	String 0..64	The password of the ESPs WiFi Access Point
AP WiFi channel	1..13	The 2.4G WiFi band of the AP. For advanced users
AP IP	-	The Access Point IPv4 address of the ESP (should always be 192.168.4.1)

LED settings

This sub-page configures the state of your lights.

Setting name	Value Range	Description
LED count	1..255	How many LEDs are in your WS2812B strip
Apply preset	0..25	Which preset to load at boot (presets can be saved via the "heart" tab in the UI)
Default RGB	3x 0..255	Standard color at startup
Default brightness	0..255	How bright the LEDs are by default
Default white	-1..255	Only applies if you got an RGBW strip
Default effect ID	0..57	Which effect to have by default
Default effect speed	0..255	The speed of the effect animation
Default effect intensity	0..255	How strong the effect is. Only used by a few effects.
Default secondary RGB(W)	4x 0..255	A secondary color is used in many effects.
Ignore and use current ...	Y/N	Ignore all "Default" fields and set the current light state to boot default
Turn on after power up	Y/N	After a reset, whether the lights should turn on
Use Gamma for brightness	Y/N	Will correct the brightness change to make it appear more linear. Advised to leave off.
Use Gamma for color	Y/N	Will correct colors to match those on a monitor. Strongly advised to keep on.
Brightness factor	1..255	Factor to change master brightness if it is to dim/bright for a certain configuration.
Fade Transition	Y/N	Whether to have a smooth fading transitional effect when changing colors/brightness
Sweep	Y/N	Whether to have a chase effect when changing colors
Invert	Y/N	Sweep effect will use the other direction
Transition delay	0..65535	How many milliseconds the transition lasts
Timed light duration	1..255	How long the nightlight should stay on
Target brightness	0..255	What brightness the light should have after time is over
Fade down	Y/N	Gradually fades down the light over the duration instead of turning it off at the end
Default overlay ID	0..7	What (clock) overlay to use. This is not fully implemented.
WARLS offset	-255..255	How many LEDs the direct UDP input should be shifted